Tesla Model X: Seat Assembly - Driver's (Remove and Replace)

Tesla Model X 2015-2024 Service Manual / Seats / Seat Assembly - Driver's (Remove and Replace)

Removal

Remove the driver's seat assembly (refer to procedure).

Installation

Installation procedure is the reverse of removal, except for the following:

Caution: Replace all Patchbolt(s).

Restore the seating profile.
Use Toolbox to update or redeploy the firmware.
Use Toolbox to run the Bitron Seat Diagnostic operation.
Use Toolbox to run the Seat Calibration operation.
Use Toolbox to run the Occupant Classification Re-Zero operation.
Use Toolbox to run the Seat Install operation.

SEE MORE:

Hinge - Hood - LH (Remove and Replace)

Removal Remove the hood assembly (refer to procedure). Remove the push clip that secures the plastic trim piece. Pull the trim piece towards the rear of the vehicle and maneuver it around the hood hinge to remove it from the vehicle. Note: The following

Location of Airbags

Airbags are located in the approximate areas shown below. Airbag warning information is printed on the sun visors. Model X is equipped with an airbag and lap/shoulder belt at both front seating positions. The airbag is a supplemental restraint at those seating positions. All occupants, including