Tesla Model X: Autosteer
NOTE: Depending on market region, vehicle configuration, options purchased, and software version, your vehicle may not be equipped with Autosteer, or the feature may not operate exactly as described.
NOTE: Autosteer is a BETA feature.
Autosteer builds upon Traffic-Aware Cruise Control (see Traffic-Aware Cruise Control), intelligently keeping Model X in its driving lane when cruising at a set speed. Autosteer also allows you to use the turn signals to move Model X into an adjacent lane (see Auto Lane Change). Autosteer detects lane markings and the presence of vehicles and objects to steer Model X.
NOTE: To display more details about the roadway and its surroundings, such as road markings, stop lights, objects (such as trash cans and poles), etc., touch Controls > Autopilot > Full Self-Driving Visualization Preview (if equipped).
CAUTION: Ensure all cameras and sensors are clean. Dirty cameras and sensors, as well as environmental conditions such as rain and faded lane markings, affect performance.
WARNING: Autosteer is a hands-on feature. You must keep your hands on the steering yoke at all times.
WARNING: Autosteer is intended for use on controlled-access highways with a fully attentive driver. When using Autosteer, hold the steering yoke and be mindful of road conditions and surrounding traffic. Do not use Autosteer in construction zones, or in areas where bicyclists or pedestrians may be present. Never depend on Autosteer to determine an appropriate driving path. Always be prepared to take immediate action. Failure to follow these instructions could cause damage, serious injury or death.
READ NEXT:
Operating Autosteer
Before you can operate Autosteer, you must enable it by
touching Controls > Autopilot > Autosteer (Beta).
To indicate that Autosteer is
available (but
not actively steering Model X), the
in
Restricted Speed
On a controlled-access highway, the cruising speed
reflects the speed limit, taking into consideration any
off set you've specified using Speed Assist. However, if
you choose to use Autosteer on re
Auto Lane Change
NOTE: Depending on market region, vehicle
configuration, options purchased, and software version,
your vehicle may not be equipped with Auto Lane
Change, or the feature may not operate exactly as
SEE MORE:
Tail Light Assembly - RH (Remove and Replace)
Removal
Remove the subwoofer
(refer to procedure).
Disconnect the electrical connector from the
tail light.
Remove the fasteners (x2) that secure the tail
light to the body (torque 2.5 Nm).
Pipes - High/Low Pressure - Rocker to Rear HVAC (Remove and Replace)
Removal
Recover refrigerant from the vehicle (refer to procedure).
Remove the RH rear wheel arch liner (refer to procedure).
Remove the mid aero shield (refer to procedure).
Remove the nuts (x2) that secure the rocker-to-rear-HVAC
high/low pressure pipes to the rocker high/l
