Tesla Model X: Lamps - Fog - Front - Adjust

1. Position the vehicle for adjusting the fog lamps:
   • In a darkened area.
   • On a level surface.
   • Perpendicular to a wall that has a matte white surface. The wall must be at least 3.7 m (12 ft) wide and 1.87 m (6 ft) high.
   • The fog lamps are 10 m (32.8 ft) away from the wall.
2. Ensure that all 4 tires are inflated to their recomended settings. Refer to General Information > Technical Data > Tire pressures.
3. If the vehicle is equipped with air suspension, set the suspension height to "High", then to "Standard".
4. Ensure that the vehicle is level by rocking it from side to side.

5. Record the height between the ground and the center of the projector lenses on the LH and RH fog lamps.
6. Measure a straight line between each of the projector lenses and the wall. At the point where each line meets the wall, mark a horizontal line 100 mm (for ECE lamps) or 130 mm (for SAE lamps) lower than what was recorded in the previous step. For example, if the height of the projector lenses on a vehicle with SAE lamps is 283 mm, mark a horizontal line 153 mm from the ground.

   Model S shown; Model X similar

   

   1	100 mm (3.94 in) (ECE lamps)
   	130 mm (5.12 in) (SAE lamps)
   2	10 m (32.8 ft)

7. Turn on the fog lamps.
8. Cover both headlamps and the RH fog lamp.
9. Insert an 8 mm socket wrench or Philips socket bit (as necessary) in the hole in the lower valance below the LH foglamp.
10. Use the socket wrench or Philips socket bit (as necessary) to adjust the fog lamp vertically so that the top beam cut off is aligned with the horizontal line marked on the wall.

    

    1	Dark area of the wall
    2	Horizontal line marked on the wall
    3	Illuminated area of the wall

11. Repeat steps 8-10 to adjust the RH fog lamp.