Tesla Model X: Pad - Lifting - Each (Remove and Replace)
Removal
If the vehicle is equipped with air suspension,
set the suspension to "High" or "Very High".
Tip: If necessary,
this procedure can be performed with the vehicle on
a 4-post lift
(refer to procedure).
Remove the bolts (x2) that secure the lifting
pad to the body (torque 10 Nm).
Remove the lifting pad from the vehicle.
Installation
Installation procedure is the reverse
of removal.
READ NEXT:
Removal
Air suspension vehicles:
Set the air suspension to the "Very High" setting.
Release the push clips (x7) and nut that secure
the front of the front wheel arch liner
Removal
Air suspension vehicles:
Set the air suspension to the "High" setting.
Open the rear door.
Remove the push clip that secures the bottom of
the rear fender
Special tool required for this procedure:
Supplier
Part Number
Description
SEE MORE:
Software
Updating software is important to ensure proper
operation and longevity of your vehicle's components.
You must install a software update at the earliest
opportunity. See Software Updates.
Tesla may update or reinstall your vehicle's software as
part of the normal diagnostic, repair, an
Remove
Remove the rocker panel molding
(refer to procedure).
Disconnect 12V power
(refer to procedure).
Disconnect the electrical connector from the
antenna.
Use a trim tool to carefully release the
antenna from the r
