Tesla Model X: Seat Assembly - 2nd Row - LH (With Broken Seat Track Motor)(Install)

Installation

1. Install a new outer track onto the seat (refer to procedure). Note: Do not fully torque that nuts that secure the track at this time.
2. Vacuum the seat and the interior of the vehicle to remove any shavings from drilling the old track.
3. Position the seat inside the vehicle.
4. Reconnect the seat harnesses.
5. Reconnect 12V power.
6. With Toolbox running, re-enter Seat Install Mode.
7. Fully move the seat backward and forward.
8. Fully torque the nuts that secure the outer track (torque 40 Nm).
9. Fully track the seat backward and forward.
10. Reinstall bolts for the rear of the seat in the following order. If any threads are damaged, discard the fastener and use a rivnut.
    • Bolts 1-4: 33 Nm
    • Bolts 5 & 6: 22 Nm

     

11. Install new bolts for the front of the seat in the following order (torque 33 Nm):

     

12. In the Toolbox Seat Install panel, run the Seat Calibration program.
13. Install a new carpet at the base of the seat.
14. Reinstall all components that were removed for access.