Tesla Model X Owners & Service Manuals

Tesla Model X: Sensor - Air Quality (Remove and Replace)

Tesla Model X 2015-2024 Service Manual / Sensor - Air Quality (Remove and Replace)

Removal

  1. Remove the front fascia (refer to procedure).
  2. Disconnect the electrical connector from the air quality sensor.

Sensor - Air Quality (Remove and Replace)

  1. Twist the sensor counterclockwise then pull it away from the front end module.

Caution: Take care not to damage component(s).

Sensor - Air Quality (Remove and Replace)

  1. Remove the air quality sensor from the vehicle.

Installation

Installation procedure is the reverse of removal.

    READ NEXT:

     Introduction

     How To Use This Manual

    General Caution: Only qualified technicians should attempt to perform the procedures contained within this manual. This manual is organized by vehicle subsystem. Click on a subsystem

     Repairs and Replacements

    Parts Only use Tesla recommended parts. Note the following: Safety features and corrosion prevention treatments embodied in the vehicle may be impaired if non Tesla recommended parts Torque wrenc

    SEE MORE:

     Wheel (Remove and Install)

    Warning: If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle. Removal Position the vehicle on a lift but do not lift it at this time. If equipped, remove the lug nut covers. Initially loosen the lug nuts (

     Latch - Hood (Remove and Replace)

    Removal Remove the front underhood apron (refer to procedure). Release both hood latch cables (x2) from the latch assembly.   Disconnect the harness connector from the LH side of the latch assembly.  

    © 2019-2024 Copyright www.teslamx.net