Tesla Model X Owners & Service Manuals

Tesla Model X: Climate

You can check the interior temperature and heat or cool the cabin before driving (even if it's in a garage), control the seat heaters, and defrost the windshield:

  • Enable or disable Defrost Car by swiping up the from bottom, which helps melt snow, ice, and frost on the windshield, windows, and mirrors.
  • Enable or disable Dog Mode or Camp Mode.
  • Customizing climate controls allows you to precondition the cabin to your desired temperature and turn on or off the steering yoke and seat heaters.
  • Vent the windows.

Using the mobile app to precondition Model X also warms the Battery as needed. The mobile app will notify you once your vehicle has reached the desired preconditioning temperature.

NOTE: In extremely cold weather or icy conditions, it is possible that your charge port latch may freeze in place. In cases where you cannot remove or insert the charge cable, or the vehicle is not Supercharging due to the latch being frozen in place, use your Tesla mobile app to enable Defrost Car for approximately 30-45 minutes. This can help thaw ice on the charge port latch so the charge cable can be removed or inserted.


Locate Model X with directions, or track its movement across a map.


You can park or retrieve Model X using Summon (see Summon) or Smart Summon (see Smart Summon).


Enable scheduled charging or departure, and precondition the vehicle. See Using Scheduled Charging and Using Scheduled Departure for more information.



    The Security tab allows you to do the following: Pair your phone to the vehicle Enable or disable Sentry Mode Enable or disable Valet Mode Enable or disable Speed Limit Mode and receive notif


     Electric Vehicle Components

    High Voltage Components Heat Pump Assembly Front Drive Unit Service Access Panel for High Voltage Components (Penthouse) High Voltage Battery High Voltage Busbars Rear Drive Unit Charge Port


     Garnish - Fender - Front - LH (Remove and Replace)

    Removal Air suspension vehicles: Set the air suspension to the "Very High" setting. Release the push clips (x7) and nut that secure the front of the front wheel arch liner to the body (torque 6 Nm). Tip: Adjust the angle of the

     Seat Assembly - 3rd Row (Remove and Replace)

    Removal Open both rear doors and the liftgate. Move the 2nd row seats into "Easy Entry" mode. Remove the trunk load floor. Carefully lift the front of the 3rd row seats to release the clips (x3) that secure them to the body of the vehicle.

    © 2019-2023 Copyright www.teslamx.net