Tesla Model X Owners & Service Manuals

Tesla Model X: Media Control Unit - Touch Screen (Remove and Replace)

Tesla Model X 2015-2023 Service Manual / Infotainment / Media Control Unit - Touch Screen (Remove and Replace)

Backup

  1. Connect a laptop with Toolbox to the vehicle.
  2. In the Toolbox "MCU Cloner" panel, select MCU Backup. Note: If the backup fails, continue to the next step. The MCU can be restored from the Instrument Cluster in the "Installation" section of this procedure instead.
  3. In the Toolbox "MCU Cloner" panel, select MCU Disable.
Removal
  1. Remove the MCU/touch screen (refer to procedure).
  2. Remove the touch screen surround trim (refer to procedure).
Installation

Installation procedure is the reverse of removal, except for the following:

Transfer the screen protector from the new touchscreen to the old one.

Restore

  1. In the Toolbox MCU Cloner panel, run the MCU Restore program. Note: If the MCU backup failed in the "Removal" section of this procedure, select MCU Restore from IC to restore the MCU files.
  2. Update the vehicle firmware.
  3. If the MCU backup failed in the "Removal" section of this procedure, open the Toolbox "Reset Remote Unlock Security Key" panel and press the Start button.

    READ NEXT:

     Media Control Unit - Touch Screen (Remove and Install)

    Warning: If the 12V power supply is disconnected, do not attempt to open the front doors with door glass in closed position. Failure to follow this instruction could result in door glas

     SD Card - Media Control Unit (Remove and Replace)

    Removal Remove the MCU/touch screen (refer to procedure). Working from the top of the MCU/touch screen, carefully use a plastic trim tool to press the SD card retaining tab away from

     Speaker - Front Door (Remove and Replace)

    Remove Remove the front door trim panel (refer to procedure). Disconnect the harness connector from the top of the speaker.   Release the bolts (x4

    SEE MORE:

     Sensor - Parking Distance - Rear - Each (Remove and Replace)

    Removal Remove the rear fascia assembly (refer to procedure). Disconnect the parking distance sensor connector.   Carefully release the parking distance sensor from the tabs that secure it to the bracket on the fascia.

     Trim - Sill Panel - Rear - LH (Remove and Replace)

    Removal Remove the welcome plate (refer to procedure). Remove the screw that secures the rear sill trim panel to the body (torque 2.5 Nm).   Remove the rear sill trim panel from the vehicle.

    © 2019-2023 Copyright www.teslamx.net