Tesla Model X Owners & Service Manuals

Tesla Model X: Summary of Cruise Indicators

Traffic-Aware Cruise Control is available but is not actively controlling your speed until you activate it. The number shown in gray is the cruising speed that will be set when you engage Traffic-Aware Cruise Control.

Traffic-Aware Cruise Control is actively cruising and is either maintaining the set speed (no vehicle in front) or is maintaining a chosen following distance from a vehicle ahead (up to the set speed).

Model X has fully stopped but is in a HOLD state. If safe, press the accelerator pedal to resume cruising at the set speed.


Traffic-Aware Cruise Control is particularly unlikely to operate as intended in the following types of situations:

  • The road has sharp curves.
  • Visibility is poor (due to heavy rain, snow, fog, etc.).
  • Bright light (such as from oncoming headlights or direct sunlight) is interfering with the view of the camera(s).
  • A camera or sensor is obstructed (fogged over, dirty, covered by a sticker, etc.).

WARNING: The list above does not represent an exhaustive list of situations that may interfere with proper operation of Traffic-Aware Cruise Control.



    NOTE: Depending on market region, vehicle configuration, options purchased, and software version, your vehicle may not be equipped with Autosteer, or the feature may not operate exactly as describe

     Operating Autosteer

    Before you can operate Autosteer, you must enable it by touching Controls > Autopilot > Autosteer (Beta). To indicate that Autosteer is available (but not actively steering Model X), the in

     Restricted Speed

    On a controlled-access highway, the cruising speed reflects the speed limit, taking into consideration any off set you've specified using Speed Assist. However, if you choose to use Autosteer on re


     Keeping Your Vehicle in Neutral (Transport Mode)

    Model X automatically shifts into Park whenever you finish driving and leave Model X. To keep Model X in Neutral when you exit, allowing it to roll freely (for example, pulling onto a flatbed truck), you must activate Transport mode: 1. Shift into Park. 2. Press the brake pedal. 3. Touch Contr

     Module - 2nd Row Seat - LH (Remove and Replace)

    Installation Remove the LH 2nd row seat back cover (refer to procedure). Disconnect the 2 harnesses from the module. Remove the fasteners (x3) that secure the module to the seat (torque 1 Nm)

    © 2019-2023 Copyright www.teslamx.net